# Sample input for StepIt.pl by Chris MacGregor (chris@bouncingdog.com)  6-24-03

# Don't change the following set commands unless you've read the Advanced Micro Systems
# manual and you (think you) know what you're doing.

set I 20     # initial velocity
set K 20     # ramp slope
set V 300    # final velocity

# for V:
#   300 seemed nice, 400 sounded yucky, 500 was pretty good, could get to 700
# or more by starting at 300 and increasing by 100-200 every few seconds.

# go home
# the "go home" is not yet reliable; use go to 0 instead
go to 0s

exec "start_sequence"

sleep 1h

go to 29.5in
exec dvgrab -output at_29.5in.dvi -frames 20000

sleep 12.5s
go up 42cm
exec start_other_camera
exec start_this_camera
exec beep               # put a noise on the tape for synchronization

go to 0cm
send m300               # find the bottom the hard way